| Themenübersicht (Neueste zuerst) |
| Geschrieben von uriel5000 - 21.07.2009, 17:34 |
danke, hatte wohl zuerst die falsche nfo (0800)...
löppt mittlerweile alles tadellos, nochmals danke.
btw. jf ist gegen die frickelei damals mit iprep ja der pure luxus! :thumbup:
grüße, macht weiter so!
|
| Geschrieben von bhoomer - 21.07.2009, 13:30 |
naja und zu deiner frage is kurz und kanpp zu sagen..
mach 1.6...
lieber immer up-to-date sein...
hat auch den vorteil dass die xbox dann nur in anführungszeichen "sichere" Spiele abspielt
|
| Geschrieben von zerofixxer - 21.07.2009, 13:18 |
Hallo,
Sorry,
wusste ich nicht genau, da ich mich noch nicht sooo lange mit Xbox beschäftige,und mein Kreon-Lw zum auslesen benutze.
Nochmals Entschuldigung..
MfG
|
| Geschrieben von JimJones - 20.07.2009, 21:18 |
zerofixxer,index.php?page=Thread&postID=85979#post85979' schrieb:Hallo,
es gibt 2. verschiedene 1.6 ixtremes..
Eine zum auslesen, die andere normal..
Wenn du dir die "Normale" flasht, kannst du alles spielen, aber halt nicht auslesen,was du aber wahscheinlich sowiso nicht willst,da du ja ein Kreon Lw hast.
Hoffe ich konnte dir etwas behilflich sein...
MfG
so ein quatsch, natürlich kann man mit der normalen (non-0800) firmware games auslesen!
Zitat:Team HyperX Presents IXtreme 1.6 firmware for Benq, Samsung and Liteon drives
------------------------------------------------------------------------------
IXtreme fw for Benq, Samsung and Liteon drives!
Features
--------
-Strict Wave 3 compliance! hybrid (modified disks) will not boot!
-Strict drive speed compliance - 12x only for game discs!
-Support for SS V2!
-Integrated 0800 for game dumping including SS v2!
-Full support for all known game exceptions! eg ddr etc!
-One shot boot mode! - allows a one off boot of gamedisc without -stealth/partition checks (will still use stealth), use activate.iso disk to activate each time!
-Support for easy drive key/version info cmd, same as liteon!
-Strict stealth/wave checking, one shot boot mode will boot wave(x)!
More Info
---------
Strict Wave 3 compliance means wave 3 games will only boot if they have correct PFI/DMI/SS and timestamp for wave 3
Strict drive speed compliance means games will only boot if drive is set for the initial speed of 12x, any modification of this make games fail to boot
SS v2 suports multiple timing samples for challenges type 5 and 7 , stroing them in the SS. This is a pre-requiste for SS v3 which has support for the so called AP2.5 check. Since this has never been used or may never be used by MS we will adopt a wait and see approach and continue to monitor for its usage.
With drive in Windows mode (Tray half open on powerup) 0800 mode is activated allowing easy dumping of game disc including SS v2. In this mode the drive is also able to output drive key, fw version and drive type by using a simple custom inquiry command.
Game exceptions are integrated in the fw for games that do not comply with the strict wave checks but are legitimate. These are Dance Dance Revolution Universe, Stoked, Ping 17 disk, afro samurai
One shot boot mode allows you to boot a Wave X or non stealth game by using the activate.iso disk as a flag. Just insert the activate disc and the next disc inserted will boot without any strict checks. This will still utilise full stealth if available. As soon as that disc is booted the flag is cleared, and you will have to re-insert the activate disk again to enable one shot boot. As always use with caution.
|
| Geschrieben von vogel123 - 20.07.2009, 21:09 |
Hi,
Also wenn du neue Spiele spielen willst benötigst du mindestens die iXtreme 1.51. Würde dir aber gleich die 1.6 empfehlen.
Die neuen Spiele haben eine dritte Videopartition, was von Firmwares unter 1.51 als nicht stealth erkannt wird, und somit nicht gebootet wird.
Klar kann man mit der 1.6 auch spielen. Auslesen ist auch möglich.
Du kannst auch weiterhin deine Spiele mit deinem Kreon LW auslesen.
Gruß
|
| Geschrieben von zerofixxer - 20.07.2009, 21:08 |
Hallo,
es gibt 2. verschiedene 1.6 ixtremes..
Eine zum auslesen, die andere normal..
Wenn du dir die "Normale" flasht, kannst du alles spielen, aber halt nicht auslesen,was du aber wahscheinlich sowiso nicht willst,da du ja ein Kreon Lw hast.
Hoffe ich konnte dir etwas behilflich sein...
MfG
|
| Geschrieben von uriel5000 - 20.07.2009, 20:52 |
hallo leute,
ich hab ixtreme 1.41 - ein update steht an. nun sah ich heute dass 1.6 draußen ist, lese zwar einerseits hier und in der nfo, dass sie nur zum auslesen ist, andererseits verwirren mich die vielen threads zur 1.6 ... also ich will weiterhin mit meinem kreon laufwerk auslesen, ist da 1.51 oder 1.6 sinniger, es steht ja eigentlich dabei, dass die 1.6er nur für isodumps ist.
oder bin ich nun total auf dem holzweg?
grüße,
uriel
|